This product is “new-open box” – the box was opened, the product was not used, tested for proper operation and is in a perfect working condition. Not in an original box. Polk Audio PSW125 12-inch Powered Subwoofer - Black Explosive performance for movies and music The evolution of high performance bass. The PSW125 Powered Subwoofer delivers powerful, accurate and musical bass at shockingly low prices. Built for power and value, the PSW125 represents a continuing refinement of the highly regarded PSW Series and a great introduction to visceral home theater bass performance. Features 12-inch Dynamic Balance Composite Woofer Driver creates “tight,” musical bass. Downward firing port couples to the room for more bass impact. More powerful motor structure for a higher BL product,(the measure of the motive force applied to the cone) results in louder, deeper and punchier bass than previous Polk woofers in this price category. Klippel Optimized woofer – By using a state-of-the-art Klippel Distortion Analyzer, Polk engineers were able to optimize the woofer’s motor structure, voice coil alignment and suspension for the best possible performance even at extreme listening levels. Compression Circuitry limits distortion at earth-shaking volume levels. Built-in High Current Amplifier supplies all the good, clean power you need for big bass. The PSW125 features a Class A/B amp. LINE and SPEAKER level inputs ensure easy hook-up compatibility with virtually any system, while the PSW125 also has an Unfiltered LFE Input for use with low-pass filtered subwoofer output jacks. Amplifier features: Adjustable Low-Pass Crossover, Phase Switch and Subwoofer Volume Control to more easily control your bass output and the sub’s blending characteristics with your front stage speakers. Signal-sensing “smart amp” Auto ON/OFF Circuitry “knows” when
Archive for the ‘build a subwoofer box’ Category
OVERVIEW OF LAB GRUPPEN C 10:8X The C 10:8X is an eight-channel amplifier that delivers 8 × 125 W* at 4 ohms, 8 ohms, 16 ohms or 70 Vrms; 250 W at 100 Vrms is available in bridge mode. The C 10:8X is one of four C…X models in the C Series, each uniquely suited for a range of installed applications with relatively lower power output requirements. C…X models share most features of the original (higher power) C Series models, and they share the same compact, lightweight 2U chassis. However, the C…X models are offered in both four- and eight-channel versions, offering even greater channel density and installation flexibility. Also, because the unique benefits of Class TD® are more applicable at higher power levels, the C…X models employ a cost-efficient proprietary Class D output design. Other features unique to C…X models include a universal power supply, selectable 35 Hz high-pass filter, and built-in GPIO control facilities. This amplifier is uniquely capable of adapting to a wide variety of demanding load conditions. Each channel has an individually configurable Voltage Peak Limiter (VPL™), which allows the output to be optimized for any loudspeaker load – whether a single large subwoofer or a series of small 70 V loudspeakers (100 V in bridge mode). VPL works in combination with adjustable input gain (adjustable in 4-channel blocks) to achieve maximum headroom regardless of input levels or output impedances. Additionally a 35 Hz high pass filter may be inserted in each 4-channel section. Every C Series amplifier is ready for the NomadLink® network right out of the box. With NomadLink, key amplifier parameters are displayed via DeviceControl software, and remote control of channel mutes and power on/off is under network control. GPIO facilities – provided exclusively on C…X models – allow access to key amplifier functions such as power on/off and fault reporting. * Maximum continuous output
OVERVIEW OF LAB GRUPPEN C 28:4 The C 28:4 is one of two mid-power, four-channel amplifiers in the C Series family. Attractively packaged in a 2U chassis, it provides 4 × 700 W output into 4 ohm loads. C Series amplifiers are uniquely capable of adapting to a wide variety of demanding load conditions. Each channel has an individually configurable Voltage Peak Limiter (VPL™), which allows the output to be optimized for any loudspeaker load – whether a single large subwoofer or a series of small 100/70 V loudspeakers. VPL works in combination with adjustable input gain to achieve maximum headroom regardless of input levels or output impedances. Every C Series is ready for the NomadLink® network right out of the box. With NomadLink, key amplifier parameters are displayed via DeviceControl software, and remote control of channel mutes and power on/off is under network control. KEY FEATURES OF LAB GRUPPEN C 28:4 Tailored to installation applications Nine unique models Wide ranging power outputs from 125 to 2200 W per channel Exclusive VPL™ (Voltage Peak Limiter) matches channel output to load Bridgeable in channel pairs Network monitoring and control via NomadLink® and DeviceControl software (NLB 60E required) Low-Z (2-16 ohms) or High-Z (70 V or 100 V) output selectable per channel Selectable input gain Craftsman-built in Kungsbacka, Sweden Power Output at 2 ohms: 4 × 700 W
Jun
JVC TH-G51 5.1-Channel 1000 Watt Home Theater System with Wireless Rear Speakers
5.1-Channel 1000 Watt Home Theater System with Wireless Rear Speakers Built-in transmitter and separate receiver for wireless rear surround sound transmission HDMI repeater input allows for easy 1 cable connection of other digital boxes Features progressive scan DVD receiver, 5 full range speakers and subwoofer Adds iPod/iPhone music and video playback through a connected dock input 1000 watts peak iPod dock included and single DVD disc HDMI output with 1080p up-conversion MP3, WMA,Dolby Digital and DTS decoding and JPEG playback Part No. TH-G51 or THG51 USA Orders Only (no international, APO and FPO orders, please). Generally leaves the warehouse in 1-2 business days. Our price is too low to show. Add to your cart for an instant lower price quote. $429.95
OVERVIEW OF LAB GRUPPEN C 5:4X The C 5:4X is a versatile four-channel amplifier, delivering 4 × 125 W* at 4 ohms, 8 ohms, 16 ohms or 70 Vrms; 250 W at 100 Vrms is available in bridge mode. The C 5:4X is one of four C…X models in the C Series, each uniquely suited for a range of installed applications with relatively lower power output requirements. C…X models share most features of the original (higher power) C Series models, and they share the same compact, lightweight 2U chassis. However, the C…X models are offered in both four- and eight-channel versions, offering even greater channel density and installation flexibility. Also, because the unique benefits of Class TD® are more applicable at higher power levels, the C…X models employ a cost-efficient proprietary Class D output design. Other features unique to C…X models include a universal power supply, selectable 35 Hz high-pass filter, and built-in GPIO control facilities. This amplifier is uniquely capable of adapting to a wide variety of demanding load conditions. Each channel has an individually configurable Voltage Peak Limiter (VPL™), which allows the output to be optimized for any loudspeaker load – whether a single large subwoofer or a series of small 70 V loudspeakers (100 V in bridge mode). VPL works in combination with adjustable input gain (adjustable in 2-channel blocks) to achieve maximum headroom regardless of input levels or output impedances. Additionally a 35 Hz high pass filter may be inserted in each 2-channel section. Every C Series amplifier is ready for the NomadLink® network right out of the box. With NomadLink, key amplifier parameters are displayed via DeviceControl software, and remote control of channel mutes and power on/off is under network control. KEY FEATURES OF LAB GRUPPEN C 5:4X Tailored to installation applications Nine unique models Wide ranging power outputs from 125 to 2200 W per channel Exclusive VPL™
Product Description: The Phonic Impression Series is a complete line of sound reinforcement speakers and subwoofers for use on stage and as floor monitors. Impression speakers include 2-way and dual 2-way stage speakers ranging in size from 12″ to 15″ with peak outputs of 600, 800 and 1200 watts. Subwoofers are available in 15″ and 18″ with peak output of 1600 watts. They feature wide frequency responses and sound pressure levels between 96 - 100 dB. The built-in 35 mm stand mounts and trapezoidal enclosure construction mean youll never be at a loss for placement of these speakers. Product Overview: Power handling (Program / Peak): 800 / 1600 W High sound pressure level: 98 dB SPL @ 1 W / 1 M Frequency response: 38 Hz ~ 250 Hz Durable die-cast handles One 35 mm socket on top for pole mounting Speakon-type connectors and 1/4″ phone jacks (In and Link Out) Solid steel grille protection Product Specifications: Type 15″ Subwoofer Power Hendling [Watts] 400/800/1600 RMS/Program/Peak Frequency Response [Hz] 3B-250HZ Sensitivity @ 1 W/1 M (+2/-1 dB] 98 dB Nominal Impedance [ohms] 4 Dispersion angle [degrees) N/A Tweeter Diaphragm N/A Connectors Two professional speaker sockets and two 1/4″ phone jacks Appearance Black Carpet Stand Socket [35 mm) Top Box Rectangular Dimensions (HxWxD) 24.9×18.3″x13.2″ [63.2×46.4×33.5 cm) Net Weight 58.4 lbs [26.5 Kg)
KEF PSW2500 Powered Subwoofer (Silver)KEF PSW2500 Powered Subwoofer (Silver) Product Description The latest addition to KEF’s Q series, the multi-purpose PSW2500 powered subwoofer has an attractive curved cabinet which is heavily braced to eliminate any unwanted “”‘box coloration”". Using a 250-millimeter long-throw bass driver and a 250-watt built-in amplifier; this closed box design will deliver ground-shaking effects and depth, whether it is a movie or music. The PSW2500 also incorporates many new features such as ground lift ability and switchable movie/music modes. The subwoofer will compliment any music or multi-channel system, and is available in the same attractive finishes as the rest of the Q series.
100% plexiglass box. 4-8″ and 2-12″ neons that flash to the beat of the music. 2-12″ WCC subs and 1 (soon to be 2) T1500 Rockford Fosgate Amp(s) @0.5 ohms. would build for someone else for $$$. Check out biga48197 for the original vid. some of the description is off though.
Duration : 0:2:40
Product Description: The Phonic Impression Series is a complete line of sound reinforcement speakers and subwoofers for use on stage and as floor monitors. Impression speakers include 2-way and dual 2-way stage speakers ranging in size from 12″ to 15″ with peak outputs of 600, 800 and 1200 watts. Subwoofers are available in 15″ and 18″ with peak output of 1600 watts. They feature wide frequency responses and sound pressure levels between 96 - 100 dB. The built-in 35 mm stand mounts and trapezoidal enclosure construction mean youll never be at a loss for placement of these speakers. Product Overview: Power handling (Program / Peak): 800 / 1600 W High sound pressure level: 99 dB SPL @ 1 W / 1 M Frequency response: 33 Hz ~ 250 Hz Durable die-cast handles One 35 mm socket on top for pole mounting Speakon-type connectors and 1/4″ phone jacks (In and Link Out) Solid steel grille protection Product Specifications: Type 18″ Subwoofer Power Hendling [Watts] 400/800/1600 RMS/Program/Peak Frequency Response [Hz] 33-250KHZ Sensitivity @ 1 W/1 M (+2/-1 dB] 99 dB Nominal Impedance [ohms] 4 Dispersion angle [degrees) N/A Tweeter Diaphragm N/A Connectors Two professional speaker sockets and two 1/4″ phone jacks Appearance Black Carpet Stand Socket [35 mm) Top Box Rectangular Dimensions (HxWxD) 33.9″x26.8″x18.3″ (86×68x46.5 cm) Net Weight 101 lbs (45.7 Kg)
External Sound Box - USB - 24 bit - External General Information Manufacturer Zalman Tech Co,, LTD Manufacturer Part Number ZMRSSC Manufacturer Website Address www.zalmanusa.com Brand Name Zalman Product Name ZM-RSSC Sound Card Marketing Information Small and Compact Easy-to-Connect Plug-n-Play USB Interface This product supports both optical and coaxial types of digital outputs along with analog 5.1 channel outputs 3 Volume controls provide independent level adjustments for the Front, Rear and Center/Subwoofer output channels A built-in amplifier provides full sound and ease of use Product Type External Sound Box Technical Information Host Interface USB Sampling Rate 24bit 96kHz ADC 24bit 96kHz DAC DAC Data Width 24bit Sound Channels 5.1 Platform Support PC Interfaces/Ports Interfaces/Ports 3 x 3.5mm Stereo Jack Audio Line Out - Front, Rear, Center/Subwoofer 1 x Mini-phone Mono Audio Line Out - Digital (Both Coaxial and Optical) Physical Characteristics Form Factor External Dimensions 0.59″ Height x 3.15″ Width x 4.25″ Depth Miscellaneous Package Contents Sound Card Main Board 1 EA USB Cable 1 EA